Internet Engineering Task Force H. Stenn
Internet-Draft Network Time Foundation
Intended status: Standards Track February 22, 2018
Expires: August 26, 2018

Network Time Protocol Extended Information Extension Field
draft-stenn-ntp-extended-information-02

Abstract

The network packet format used by NTP has changed very little between NTPv1, defined by RFC 958 in 1985, and NTPv4, defined by RFC 5905. The core network packet used by NTP has no spare bits available for reporting additional state information and no larger data areas available for larger amounts of information. This proposal offers a new extension field that would contains this additional information.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on August 26, 2018.

Copyright Notice

Copyright (c) 2018 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.


Table of Contents

1. Introduction

The core NTP packet format has changed little since RFC 958 was published in 1985. Since then, there has been demonstrated need to convey additional information about NTP's state in an NTP packet, but no backward-compatible way to usurp the few otherwise potentially available bits has been found, and no larger data areas are available in the core packet structure. This proposal offers a new extension field that would contain this additional information.

1.1. Requirements Language

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119.

2. The Extended Information Extension Field

The Field Type of the Extended Information EF includes a version specification, to make it easier to evolve this specification.

 0                   1                   2                   3
 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+---------------+---------------+-------------------------------+ 
|          Field Type           |        Field Length           |
+-------------------------------+-------------------------------+ 
|     Content Descriptor 1      |       Content Data 1          | 
+---------------------------------------------------------------+

NTP Extension Field: Extended Information

Field Type: TBD (Recommendation for IANA: 0x0009 (Extended-Information), 0x0109 (Extended-Information Version 1)

Field Length: as needed

Payload: For Version 1, a two octet Content Descriptor field and a two octet Content Data field, as described below.

Version 1 Content fields.

 Content Descriptor 1     Content Data 1
         0x0001         TAI offset in the low-order 8 bits, 24-31
         0x0002         Interleave Mode indicator in Bit 23
         0xFFFD         Reserved (Zeroes)

 Interleave Mode: 1 if the sender is in interleave mode, 0 otherwise

NTP Extension Field: Extended Information Version 1 Content Fields

Example: A system that wants to convey an offset to TAI of 36 seconds, and show it is in interleave mode.

 0                   1                   2                   3
 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+---------------+---------------+-------------------------------+ 
|    Field Type (0x0109)        |   Field Length (0x0008)       |
+-------------------------------+-------------------------------+ 
|            0x0003             |           0x0124              | 
+-------------------------------+-------------------------------+

NTP Extension Field: Extended Information V1, Example

3. Acknowledgements

The author wishes to acknowledge the contributions of Martin Burnicki.

4. IANA Considerations

This memo requests IANA to allocate NTP Extension Field Types

for this proposal.

5. Security Considerations

Additional information TBD

6. Normative References

[RFC0958] Mills, D., "Network Time Protocol (NTP)", RFC 958, DOI 10.17487/RFC0958, September 1985.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997.
[RFC5905] Mills, D., Martin, J., Burbank, J. and W. Kasch, "Network Time Protocol Version 4: Protocol and Algorithms Specification", RFC 5905, DOI 10.17487/RFC5905, June 2010.

Author's Address

Harlan Stenn Network Time Foundation P.O. Box 918 Talent, OR, 97540 US EMail: stenn@nwtime.org