Border Gateway Protocol 4 (BGP-4) Send Hold TimerFastlyAmsterdamNetherlandsjob@fastly.comLondonUnited Kingdomben@benjojo.co.uk
Routing
IDRBGPsessionTCPEBGP
This document defines the SendHoldTimer session attribute for the Border Gateway Protocol (BGP) Finite State Machine (FSM).
Implementation of a SendHoldTimer should help overcome situations where BGP sessions are not terminated after it has become detectable for the local system that the remote system is not processing BGP messages.
For robustness, this document specifies that the local system should close BGP connections and not solely rely on the remote system for session tear down when BGP timers have expired.
This document updates RFC4271.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119.
This document defines the SendHoldTimer session attribute for the Border Gateway Protocol (BGP) Finite State Machine (FSM) defined in section 8.
Failure to terminate a 'stuck' BGP session can result in Denial Of Service, the subsequent failure to generate and deliver BGP WITHDRAW messages to other BGP peers of the local system is detrimental to all participants of the inter-domain routing system.
This phenomena is theorised to have contributed to IP traffic backholing events in global Internet routing system
This specification intends to improve this situation by requiring sessions to be terminated if the local system has detected that the remote system cannot possibly have received any BGP messages for the duration of the SendHoldTimer.
Through codification of the aforementioned requirement, operators will benefit from consistent behavior across different BGP implementations.
BGP speakers following this specification do not exclusively rely on remote systems robustly closing connections, but will also locally close connections.
A malfunctioning or overwhelmed peer may cause data on the BGP socket in the local system to back up, and the current RFC specification will not cause the session to be torn down.
For example, as BGP runs over TCP it is possible for hosts in the ESTABLISHED state to encounter a BGP peer that is advertising a TCP Receive Window (RCV.WND) of size zero and thus preventing the local system from sending KEEPALIVE, CEASE, WITHDRAW, UPDATE, or other critical messages across the wire.
At the moment of writing, most BGP implementations appear unable to handle this situation in a robust fashion.
Generally BGP implementation have no visibility into lower-layer subsystems such as TCP or the peer's current Receive Window.
Therefor this document banks on BGP implementations being able to detect an inability to push more data to the remote peer, at which point the SendHoldTimer starts.
BGP speakers are implemented following a conceptual model "BGP Finite State Machine" (FSM), which is outlined in section 8 of .
This specification updates the BGP FSM as following:
The following mandatory session attributes are added to paragraph 6 of Section 8, before "The state session attribute indicates the current state of the BGP FSM":
9) SendHoldTimer
10) SendHoldTime (an initial value of 4 minutes is recommended)
Section 8.1.3 is extended as following:
If the SendHoldTimer_Expires (Event XX), the local system:
logs a message with the BGP Error Notification Code "Send Hold Timer Expired",releases all BGP resources,sets the ConnectRetryTimer to zero,drops the TCP connection,increments the ConnectRetryCounter,(optionally) performs peer oscillation damping if the DampPeerOscillations attribute is set to TRUE, andchanges its state to Idle.
If the DelayOpenTimer_Expires event (Event 12) occurs in the Connect state, the local system:
sends an OPEN message to its peer,sets the HoldTimer to a large value, andsets the SendHoldTimer to a large value, andchanges its state to OpenSent.
If the DelayOpen attribute is set to FALSE, the local system:
stops the ConnectRetryTimer (if running) and sets the ConnectRetryTimer to zero,completes BGP initializationsends an OPEN message to its peer,sets the HoldTimer to a large value, andsets the SendHoldTimer to a large value, andchanges its state to OpenSent.
A HoldTimer value of 4 minutes is suggested.
A SendHoldTimer value of 4 minutes is suggested.
If a system does not send and receive successive KEEPALIVE, UPDATE, and/or NOTIFICATION messages within the period specified in the Send Hold Time, then the BGP connection is closed and a log message is emitted.
This section records the status of known implementations of the protocol defined by this specification at the time of posting of this Internet-Draft, and is based on a proposal described in RFC 7942.
The description of implementations in this section is intended to assist the IETF in its decision processes in progressing drafts to RFCs.
Please note that the listing of any individual implementation here does not imply endorsement by the IETF.
Furthermore, no effort has been spent to verify the information presented here that was supplied by IETF contributors.
This is not intended as, and must not be construed to be, a catalog of available implementations or their features.
Readers are advised to note that other implementations may exist.
According to RFC 7942, "this will allow reviewers and working groups to assign due consideration to documents that have the benefit of running code, which may serve as evidence of valuable experimentation and feedback that have made the implemented protocols more mature.
It is up to the individual working groups to use this information as they see fit".
OpenBGPD
The authors would like to thank
William McCall
and
Theo de Raadt
for their helpful review of this document.
This specification addresses the vulnerability of a BGP speaker to a potential attack whereby a BGP peer can pretend to be unable to process BGP messages and in doing so create a scenario where the local system is poisoned with stale routing information.
There are three detrimental aspects to the problem of not robustly handling 'stuck' peers:
Failure to send BGP messages to a peer implies the peer is operating based on stale routing information.
Failure to disconnect from a 'stuck' peer hinders the local system's ability to construct a non-stale local Routing Information Base (RIB).
Failure to disconnect from a 'stuck' peer hinders the local system's ability to inform other BGP peers with current network reachability information.
In other respects, this specification does not change BGP's security characteristics.
This document requests IANA to assign a value named "Send Hold Timer Expired" in the "BGP Error (Notification) Codes" sub-registry under the "Border Gateway Protocol (BGP) Parameters" registry.
Level 3 problem sparks temporary outage for some U.S. telecommsReutersbgpd send side hold timerOpenBSD