Internet-Draft BMP REL October 2023
Lucente & Cardona Expires 25 April 2024 [Page]
Workgroup:
Global Routing Operations
Internet-Draft:
draft-lucente-grow-bmp-rel-03
Updates:
7854 (if approved)
Published:
Intended Status:
Standards Track
Expires:
Authors:
P. Lucente
NTT
C. Cardona
NTT

Logging of routing events in BGP Monitoring Protocol (BMP)

Abstract

The BGP Monitoring Protocol (BMP) does provision for BGP session event logging (Peer Up, Peer Down), state synchronization (Route Monitoring), debugging (Route Mirroring) and Statistics messages, among the others. This document defines a new Route Event Logging (REL) message type for BMP with the aim of covering use-cases with affinity to alerting, reporting and on-change analysis.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 25 April 2024.

Table of Contents

1. Introduction

As NLRIs are advertised and distributed, policies are applied and, as a result, actions are performed on them. Currently, in order to infer the outcome of an evaluation process, a comparative analysis needs to be performed between Route Monitoring data for two distinct observation points of interest, for example Adj-Rib-In pre-policy and post-policy. It would be instead more useful if a monitored router could export event-driven data with the relevant information.

The envisioned use-cases are the most diverse and range from logging route filtering to reporting the outcome of validation processes taking place on the monitored router, to isolating certain subsets of data to be validated offline, to report malformed BGP packets, to broader closed-loop operations.

Since no other existing BMP message type does fit the described purpose, this document defines a new Route Event Logging (REL) message type that is suitable to carry event-driven data and is extensible in nature. While the message format is similar to the Route Mirroring message type defined in RFC 7854 [RFC7854] and to the Route Monitoring message type as defined in TLV support for BMP Route Monitoring and Peer Down Messages [I-D.ietf-grow-bmp-tlv], the semantics are different.

2. Terminology

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 RFC 2119 [RFC2119] RFC 8174 [RFC8174] when, and only when, they appear in all capitals, as shown here.

3. Route Event Logging (REL) message

In basic terms a REL message does carry Events. Each Event is logically composed by one Event Subject and one or more Event Attributes.

The structure of the Route Event Logging message is the same as the Route Monitoring message defined in TLV support for BMP Route Monitoring and Peer Down Messages [I-D.ietf-grow-bmp-tlv] where the Per-Peer Header is followed by a BGP Message TLV, one indexed Informational TLV and further optional indexed Informational TLVs. An example of such structure is available in Section 4.2.1.1 of [I-D.ietf-grow-bmp-tlv].

One or more Event Subjects are packed as part of a BGP Update PDU. The BGP Update PDU Section 4.3 of [RFC4271] is encoded itself as part of a BGP Message TLV with code point TBD1 and index set to zero. Each Event Subject is represented by an NLRI carried in the PDU.

The BGP Message TLV may be preceeded and/or followed by indexed Informational TLVs that carry Event Attributes, where attributes are bound to subjects referring to their positional index within the PDU or via a Group TLV as described in Section 4.2.1 of [I-D.ietf-grow-bmp-tlv]

Speaking comparatively to other existing message types, REL does not require an initial flooding of information as per the state synchronization nature of Route Monitoring and does not aim to provide a non-state-compressed full-fidelity view of all messages received as per the debugging nature of Route Mirroring.

In the context of BMP REL message, and hence in the reminder of this document, the term Event Subject and NLRI will be used interchangeably. Also the term Event Attribute and Informational TLV will be used interchangeably.

The following sections will describe each component of the REL message in more detail.

3.1. Per-Peer Header

The message does start with a BMP per-peer header as defined in RFC 7854 [RFC7854], subsequently extended by RFC 8671 [RFC8671] and RFC 9069 [RFC9069] allowing, among the other things, to timestamp an Event and set its observation point among those defined in BMP.

Because the main purpose of the REL message is to log events at the time of applying an action, the Peer Flags field - even if applied to Adj-Rib-In or Adj-Rib-Out does not have the concept of pre- and post-policy. The flags are hence defined as follows:

 0 1 2 3 4 5 6 7
+-+-+-+-+-+-+-+-+
|V|A| Reserved  |
+-+-+-+-+-+-+-+-+

The V flag and A flag do carry the same meaning as originally defined by RFC 7854 [RFC7854]. The remaining bits are reserved for future use. They MUST be transmitted as 0 and their values MUST be ignored on receipt.

3.2. BGP Update PDU

The PDU enclosed as part of a BGP Message TLV is artificial, either packed from scratch or repacked starting from an existing BGP Update PDU to only contain the relevant NLRIs affected by an Event (one or multiple). The Event is going to be further described by means of Event Attributes by indexed Informational TLVs.

The choice of describing one or multiple Event Subjects via a BGP Update PDU is because, on one hand, this does allow to not have to invent new encodings for NLRIs, while on the other, to support all types and encodings already supported by BGP. The advantage being that only minimal new code, on both the exporting and the receiving sides, will have to be produced.

3.3. Informational TLVs

Informational TLVs in BMP are formalized by the intersection of RFC 7854 [RFC7854], TLV support for BMP Route Monitoring and Peer Down Messages [I-D.ietf-grow-bmp-tlv] and Support for Enterprise- specific TLVs in the BGP Monitoring Protocol [I-D.ietf-grow-bmp-tlv-ebit]. TLVs in a REL message are indexed.

Contrary to other BMP messages where all Informational TLVs are entirely optional, in order for a REL message to be meaningful, it MUST contain at least one Event Reason TLV per Event Subject (ie. NLRI) carried by the BGP Update PDU and MAY contain further optional attribute TLVs to further characterize the Event.

A new registry called "Route Event Logging TLVs" is defined and is seeded with the TLVs detailed in the following sections.

3.3.1. Event Reason TLV

TBD2 = Event Reason TLV (4 octets). Indicates the IANA-registered reason code describing the type of the event. The following reason codes are defined as part of the "Event Reason TLV" registry:

+--------+----------------------+
| Value  | Reason               |
+-------------------------------+
| 0x0000 | Unknown              |
| 0x0001 | Log Action           |
| 0x0002 | Policy Discard       |
| 0x0004 | Validation Fail      |
| 0x0008 | Malformed Packet     |
+--------+----------------------+

     Table 1: Event Reason Codes

3.3.2. Policy Discard TLV

TBD3 = Policy Discard TLV. The value contains a UTF-8 string whose value MUST be equal to the value of the routing policy name that caused the discard. The string size MUST be within the range of 1 to 255 bytes.

4. Operational Considerations

Route Event Logging messages are event-driven in nature so the general recommendation is to use them to report on specific conditions of interest in order, for example, to facilitate data mining or avoid differential analysis. When the objective is to annotate every received or announced NLRI then the recommendation is to use Route Monitoring messages with BMP Path Marking [I-D.ietf-grow-bmp-path-marking-tlv]. As an example consider RPKI validation status: when the objective is to report on any validations tatus (ie. valid, invalid and unknown), BMP Path Marking should be used; when the objective is instead to report only invalids then Route Event Logging with Validation Fail Event Reason should be used.

5. Security Considerations

It is not believed that this document adds any additional security considerations.

6. IANA Considerations

TBD

7. References

[I-D.ietf-grow-bmp-path-marking-tlv]
Cardona, C., Lucente, P., Francois, P., Gu, Y., and T. Graf, "BMP Extension for Path Status TLV", Work in Progress, Internet-Draft, draft-ietf-grow-bmp-path-marking-tlv-00, , <https://datatracker.ietf.org/doc/html/draft-ietf-grow-bmp-path-marking-tlv-00>.
[I-D.ietf-grow-bmp-tlv]
Lucente, P. and Y. Gu, "TLV support for BMP Route Monitoring and Peer Down Messages", Work in Progress, Internet-Draft, draft-ietf-grow-bmp-tlv-12, , <https://datatracker.ietf.org/doc/html/draft-ietf-grow-bmp-tlv-12>.
[I-D.ietf-grow-bmp-tlv-ebit]
Lucente, P. and Y. Gu, "Support for Enterprise-specific TLVs in the BGP Monitoring Protocol", Work in Progress, Internet-Draft, draft-ietf-grow-bmp-tlv-ebit-03, , <https://datatracker.ietf.org/doc/html/draft-ietf-grow-bmp-tlv-ebit-03>.
[RFC2119]
Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, , <https://www.rfc-editor.org/info/rfc2119>.
[RFC4271]
Rekhter, Y., Ed., Li, T., Ed., and S. Hares, Ed., "A Border Gateway Protocol 4 (BGP-4)", RFC 4271, DOI 10.17487/RFC4271, , <https://www.rfc-editor.org/info/rfc4271>.
[RFC7854]
Scudder, J., Ed., Fernando, R., and S. Stuart, "BGP Monitoring Protocol (BMP)", RFC 7854, DOI 10.17487/RFC7854, , <https://www.rfc-editor.org/info/rfc7854>.
[RFC8174]
Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, , <https://www.rfc-editor.org/info/rfc8174>.
[RFC8671]
Evens, T., Bayraktar, S., Lucente, P., Mi, P., and S. Zhuang, "Support for Adj-RIB-Out in the BGP Monitoring Protocol (BMP)", RFC 8671, DOI 10.17487/RFC8671, , <https://www.rfc-editor.org/info/rfc8671>.
[RFC9069]
Evens, T., Bayraktar, S., Bhardwaj, M., and P. Lucente, "Support for Local RIB in the BGP Monitoring Protocol (BMP)", RFC 9069, DOI 10.17487/RFC9069, , <https://www.rfc-editor.org/info/rfc9069>.

Acknowledgements

The authors would like to thank Jeff Haas and Luuk Hendriks for their valuable input. The authors would also like to thank Mike Booth for his review.

Authors' Addresses

Paolo Lucente
NTT
Veemweg 23
3771 Barneveld
Netherlands
Camilo Cardona
NTT
164-168, Carrer de Numancia
08029 Barcelona
Spain