IPv6 Operations A. Yourtchenko
Internet-Draft Cisco
Intended status: Best Current Practice L. Colitti
Expires: March 10, 2016 Google
September 7, 2015

Reducing energy consumption of Router Advertisements


Frequent Router Advertisement messages can severely impact host power consumption. This document recommends operational practices to avoid such impact.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at http://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on March 10, 2016.

Copyright Notice

Copyright (c) 2015 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.

Table of Contents

1. Introduction

Routing information is communicated to IPv6 hosts by Router Advertisement (RA) messages [RFC4861]. If these messages are too frequent, they can severely impact power consumption on battery-powered hosts.

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].

2. Problem scenarios

2.1. Solicited multicast RAs on large networks

On links with a large number of battery-powered devices, sending solicited Router Advertisements multicast can severely impact host power consumption. This is because every time a device joins the network, all devices on the network receive a multicast Router Advertisement. In the worst case, if devices are continually joining and leaving the network, and the network is large enough, then all devices on the network will receive solicited Router Advertisements at the maximum rate specified by section 6.2.6 of [RFC4861], which is one every 3 seconds.

2.2. Frequent periodic Router Advertisements

Some networks send periodic multicast Router Advertisements very frequently (e.g., once every few seconds). This may be due to a desire to ensure that hosts always have access to up-to-date router information. This has severe impact on battery life.

3. Consequences

Observed reactions to frequent Router Advertisement messages by battery-powered devices include:

Compounding the problem, when dealing with devices that drop Router Advertisements when in power saving mode, some network administrators work around the problem by sending RAs even more frequently. This causes devices to engage in even more aggressive filtering.

4. Recommendations

4.1. Network-side recommendations

  1. Router manufacturers SHOULD allow network administrators to configure the routers to respond to Router Solicitations with unicast Router Advertisements if:
  2. Administrators of networks that serve large numbers (tens or hundreds) of battery-powered devices SHOULD enable this behaviour.
  3. Networks that serve battery-powered devices SHOULD NOT send multicast RAs too frequently (e.g., more than one every 5-10 minutes for current battery-powered devices) unless the information in the RA packet has substantially changed. If there is a desire to ensure that hosts pick up configuration changes quickly, those networks MAY send frequent Router Advertisements for a limited period of time (e.g., not more than one minute) immediately after a configuration change.

No protocol changes are required. Responding to Router Solicitations with unicast Router Advertisements is already allowed by section 6.2.6 of [RFC4861], and Router Advertisement intervals are already configurable by the administrator to a wide range of values.

4.2. Device-side recommendations

  1. Mobile devices that intend to maintain IPv6 connectivity while asleep MUST NOT ignore RAs while asleep.
  2. Mobile devices that do not intend to maintain IPv6 connectivity while asleep SHOULD disconnect from the IPv6 network and SHOULD reconnect to the network (including performing any DNAv6 procedures [RFC6059], sending Router Solicitations and performing Duplicate Address Detection) when waking up.

5. Acknowledgements

The authors wish to thank Steven Barth, Frank Bulk, David Farmer, Ray Hunter, Erik Kline, Erik Nordmark, Alexandru Petrescu, Libor Polcak, Mark Smith, and Jinmei Tatuya for feedback and helpful suggestions.

6. IANA Considerations


7. Security Considerations


8. Normative References

[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997.
[RFC4861] Narten, T., Nordmark, E., Simpson, W. and H. Soliman, "Neighbor Discovery for IP version 6 (IPv6)", RFC 4861, DOI 10.17487/RFC4861, September 2007.
[RFC6059] Krishnan, S. and G. Daley, "Simple Procedures for Detecting Network Attachment in IPv6", RFC 6059, DOI 10.17487/RFC6059, November 2010.

Authors' Addresses

Andrew Yourtchenko Cisco 7a de Kleetlaan Diegem, 1831 Belgium Phone: +32 2 704 5494 EMail: ayourtch@cisco.com
Lorenzo Colitti Google Roppongi 6-10-1 Minato, Tokyo 106-6126 JP EMail: lorenzo@google.com