SIPCORE Working Group C. Holmberg
Internet-Draft I. Sedlacek
Updates: 5621 (if approved) Ericsson
Intended status: Standards Track May 8, 2017
Expires: November 9, 2017

Content-ID header field in Session Initiation Protocol (SIP)
draft-ietf-sipcore-content-id-04

Abstract

This document specifies the Content-ID header field for usage in the Session Initiation Protocol (SIP). The document also updates RFC 5621, to enable a Content-ID URL to reference a complete message-body and metadata provided by some additional SIP header fields.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at http://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on November 9, 2017.

Copyright Notice

Copyright (c) 2017 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.


Table of Contents

1. Introduction

1.1. Identifying a body part

A SIP message consists of a start-line, one or more header fields, an empty line indicating the end of the header fields, and an optional message-body, as specified in [RFC3261].

The message-body can be a non-multipart message-body or a multipart message-body as specified in [RFC3261].

[RFC5621] defines generic handling of a multipart message-body in a SIP message.

A multipart message-body contains zero, one or several body parts, encoded using [RFC2045] format.

A body part in the multipart message-body is described using header fields such as Content-Disposition, Content-Encoding, and Content-Type, which provide information on the content of the body part, as specified in [RFC5621]. A body part in the multipart message-body can also contain a Content-ID header field with an ID value uniquely identifying the body part, as specified in [RFC2045].

1.2. Referencing a body part

A SIP header field can reference a body part using a Content-ID URL, as specified in [RFC5621].

The Content-ID URL is specified in [RFC2392]. [RFC2392] specifies how to identify the body part referenced by a Content-ID URL. The Content-ID URL value is included in the Content-ID header field of the body part.

Examples of SIP header fields referencing a body part using a Content-ID URL are:

1.3. Problem statement

It is currently not specified how to uniquely identify a complete message-body of a SIP message using a Content-ID header field, and how to reference a complete message-body using a Content-ID URL.

1.4. Consequences

The examples below shows the consequences of the problem described above.

1.4.1. Example 1

If a UAC sends an INVITE request conveying location as specified in [RFC6442], if the UAC decides not to include an SDP offer, and if the location is conveyed by value, then the UAC needs to include only one MIME entity in the INVITE request. This content can be e.g. of the application/pidf+xml MIME type.

However, due to [RFC6442] requiring inclusion of a Geolocation header field referencing the body part with the location information, the UAC includes a multipart message-body with single body part in the INVITE request, and includes the location information of application/pidf+xml MIME type and an associated Content-ID header field in the body part.

1.4.2. Example 2

If a UAC sends an REFER request including a list of targets as specified in [RFC5368], then the UAC needs to include only one MIME entity in the REFER request. This content is of the application/resource-lists+xml MIME type.

However, due to [RFC5368] requiring inclusion of a Refer-To header field referencing the body part containing the list of targets, the UAC includes a multipart message-body with single body part in the REFER request, and includes the list of targets of application/resource-lists+xml MIME type and an associated Content-ID header field in the body part.

1.5. Solution

In order to solve the problems described above, this document:

NOTE: In [RFC5621], the Content-ID URL references a specific body part only.

2. Conventions

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].

3. Content-ID header field

3.1. Introduction

This section defines the usage of the Content-ID header field for SIP.

3.2. Syntax

The ABNF [RFC5234] for the Content-ID header field is:


   Content-ID = "Content-ID" HCOLON msg-id

   msg-id     = "<" id-left "@" id-right ">"

   NOTE: id-left and id-right are specified in [RFC5322]. HCOLON is
   defined in [RFC3261].

   NOTE: When used in a SIP header field, the msg-id syntax has been
   simplified compared to the syntax in [RFC5322].

       

3.3. Semantics

The Content-ID header field included in the header fields of a SIP message identifies the message-body of the SIP message, and the metadata provided by:

The Content-ID header field can be included in any SIP message which is allowed to contain a message-body.

3.4. Procedures

3.4.1. UA procedures

A UA MAY include a Content-ID header field in any SIP message that is allowed to contain a message-body.

A UA MUST NOT include a Content-ID header field in any SIP message that is not allowed to contain a message-body.

The UA MUST set the value of the Content-ID header field to a globally unique value.

3.4.2. Proxy procedures

A proxy MUST NOT add a Content-ID header field in a SIP message.

A proxy MUST NOT modify a Content-ID header field included in a SIP message.

A proxy MUST NOT delete a Content-ID header field from a SIP message.

4. Update to RFC 5621

This section updates section 9.1 of [RFC5621], by allowing a Content-ID URL to reference a message-body and the related metadata (Section 3.3), in addition to allowing a reference to a body part.


OLD TEXT:

   Content-ID URLs allow creating references to body parts.  A given
   Content-ID URL [RFC2392], which can appear in a header field or
   within a body part (e.g., in an SDP attribute), points to a
   particular body part.


NEW TEXT:

   Content-ID URLs allow creating references to body parts or
   message-bodies (and the header fields describing the
   message-bodies). A given Content-ID URL [RFC2392], which can appear
   in a header field or within a body part (e.g., in an SDP attribute),
   points to a particular body part or the message-body (and the
   header fields describing the message-body).

       

5. Security considerations

The Content-ID header field value MUST NOT reveal sensitive user information.

If the message-body associated with the Content-ID header field is an encrypted body, it MUST NOT be possible to derive a key that can be used to decrypt the body from the Content-ID header field value.

6. IANA considerations

This specification registers a new SIP header field according to the procedures in [RFC3261].

6.1. Header field

The header field described in Section 3 has been registered in the "Header Fields" sub-registry of the "Session Initiation Protocol (SIP) Parameters" registry by adding a row with these values:

[RFC EDITOR NOTE: Please replace XXXX with the RFC number of this document when publishing]

   Header Name:  Content-ID

   compact:

   Reference:  RFCXXXX
       

7. Change log

[RFC EDITOR NOTE: Please remove this section when publishing]

Changes from draft-ietf-sipcore-content-id-03

Changes from draft-ietf-sipcore-content-id-02

Changes from draft-ietf-sipcore-content-id-01

8. Normative references

[RFC2045] Freed, N. and N. Borenstein, "Multipurpose Internet Mail Extensions (MIME) Part One: Format of Internet Message Bodies", RFC 2045, DOI 10.17487/RFC2045, November 1996.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997.
[RFC2392] Levinson, E., "Content-ID and Message-ID Uniform Resource Locators", RFC 2392, DOI 10.17487/RFC2392, August 1998.
[RFC5234] Crocker, D. and P. Overell, "Augmented BNF for Syntax Specifications: ABNF", STD 68, RFC 5234, DOI 10.17487/RFC5234, January 2008.
[RFC5322] Resnick, P., "Internet Message Format", RFC 5322, DOI 10.17487/RFC5322, October 2008.
[RFC3261] Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A., Peterson, J., Sparks, R., Handley, M. and E. Schooler, "SIP: Session Initiation Protocol", RFC 3261, DOI 10.17487/RFC3261, June 2002.
[RFC5368] Camarillo, G., Niemi, A., Isomaki, M., Garcia-Martin, M. and H. Khartabil, "Referring to Multiple Resources in the Session Initiation Protocol (SIP)", RFC 5368, DOI 10.17487/RFC5368, October 2008.
[RFC5621] Camarillo, G., "Message Body Handling in the Session Initiation Protocol (SIP)", RFC 5621, DOI 10.17487/RFC5621, September 2009.
[RFC6442] Polk, J., Rosen, B. and J. Peterson, "Location Conveyance for the Session Initiation Protocol", RFC 6442, DOI 10.17487/RFC6442, December 2011.

Authors' Addresses

Christer Holmberg Ericsson Hirsalantie 11 Jorvas, 02420 Finland EMail: christer.holmberg@ericsson.com
Ivo Sedlacek Ericsson Sokolovska 79 Praha, 18600 Czech Republic EMail: ivo.sedlacek@ericsson.com