Internet Engineering Task Force A. Adamantiadis Internet-Draft libssh Intended status: Informational S. Josefsson Expires: September 28, 2017 SJD AB M. Baushke Juniper Networks, Inc. March 27, 2017 Secure Shell (SSH) Key Exchange Method using Curve25519 and Curve448 draft-ietf-curdle-ssh-curves-01 Abstract How to implement the Curve25519 and Curve448 key exchange methods in the Secure Shell (SSH) protocol is described. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on September 28, 2017. Copyright Notice Copyright (c) 2017 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Adamantiadis, et al. Expires September 28, 2017 [Page 1] Internet-Draft Curve25519/448 for SSH March 2017 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Key Exchange Methods . . . . . . . . . . . . . . . . . . . . 3 2.1. Shared Secret Encoding . . . . . . . . . . . . . . . . . 3 3. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 4 4. Security Considerations . . . . . . . . . . . . . . . . . . . 4 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 6. References . . . . . . . . . . . . . . . . . . . . . . . . . 5 6.1. Normative References . . . . . . . . . . . . . . . . . . 5 6.2. Informative References . . . . . . . . . . . . . . . . . 5 Appendix A. Copying conditions . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction In [Curve25519], a new elliptic curve function for use in cryptographic applications was introduced. In [Ed448-Goldilocks] the Ed448-Goldilocks curve (also known as Curve448) is described. In [RFC7748], the Diffie-Hellman functions using Curve25519 and Curve448 are specified. Secure Shell (SSH) [RFC4251] is a secure remote login protocol. The key exchange protocol described in [RFC4253] supports an extensible set of methods. [RFC5656] describes how elliptic curves are integrated in SSH, and this document reuses those protocol messages. This document describes how to implement key exchange based on Curve25519 and Curve448 in SSH. For Curve25519 with SHA-256 [RFC4634], the algorithm we describe is equivalent to the privately defined algorithm "curve25519-sha256@libssh.org", which is currently implemented and widely deployed in libssh and OpenSSH. The Curve448 key exchange method is novel but similar in spirit, and we chose to couple it with SHA-512 [RFC4634] to further separate it from the Curve25519 alternative. This document provide Curve25519 as the prefered choice, but suggests that the fall back option Curve448 is implemented to provide an hedge against unforseen analytical advances against Curve25519 and SHA-256. Due to different implementation status of these two curves (high- quality free implementations of Curve25519 has been in deployed use for several years, while Curve448 implementations are slowly appearing), it is accepted that adoption of Curve448 will be slower. The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119]. Adamantiadis, et al. Expires September 28, 2017 [Page 2] Internet-Draft Curve25519/448 for SSH March 2017 2. Key Exchange Methods The key exchange procedure is similar to the ECDH method described in chapter 4 of [RFC5656], though with a different wire encoding used for public values and the final shared secret. Public ephemeral keys are encoded for transmission as standard SSH strings. The protocol flow, the SSH_MSG_KEX_ECDH_INIT and SSH_MSG_KEX_ECDH_REPLY messages, and the structure of the exchange hash are identical to chapter 4 of [RFC5656]. The method names registered by this document are "curve25519-sha256" and "curve448-sha512". The methods are based on Curve25519 and Curve448 scalar multiplication, as described in [RFC7748]. Private and public keys are generated as described therein. Public keys are defined as strings of 32 bytes for Curve25519 and 56 bytes for Curve448. Clients and servers MUST fail the key exchange if the length of the received public keys are not the expected lengths, or if the derived shared secret only consists of zero bits. No further validation is required beyond what is discussed in [RFC7748]. The derived shared secret is 32 bytes when Curve25519 is used and 56 bytes when Curve448 is used. The encodings of all values are defined in [RFC7748]. The hash used is SHA-256 for Curve25519 and SHA-512 for Curve448. 2.1. Shared Secret Encoding The following step differs from [RFC5656], which uses a different conversion. This is not intended to modify that text generally, but only to be applicable to the scope of the mechanism described in this document. The shared secret, K, is defined in [RFC4253] as a multiple precision integer (mpint). Curve25519/448 outputs a binary string X, which is the 32 or 56 byte point obtained by scalar multiplication of the other side's public key and the local private key scalar. The 32 or 56 bytes of X are converted into K by interpreting the bytes as an unsigned fixed-length integer encoded in network byte order. This conversion follows the normal "mpint" process as described in section 5 of [RFC4251]. To clarify a corner-case in this conversion, when X is encoded as an mpint K, in order to calculate the exchange hash, it may vary as follows: Adamantiadis, et al. Expires September 28, 2017 [Page 3] Internet-Draft Curve25519/448 for SSH March 2017 o If the high bit of X is set, the mpint format requires a zero byte to be prepended. In this case, the length of the encoded K will be larger. o If X has leading zero bytes, the mpint format requires such bytes to be skipped. In this case, the length of the encoded K will be smaller. 3. Acknowledgements The "curve25519-sha256" key exchange method is identical to the "curve25519-sha256@libssh.org" key exchange method created by Aris Adamantiadis and implemented in libssh and OpenSSH. Thanks to the following people for review and comments: Denis Bider, Damien Miller, Niels Moeller, Matt Johnston. 4. Security Considerations The security considerations of [RFC4251], [RFC5656], and [RFC7748] are inherited. Curve25519 provide strong security and is efficient on a wide range of architectures, and has properties that allows better implementation properties compared to traditional elliptic curves. Curve448 with SHA-512 is similar, but have not received the same cryptographic review as Curve25519, and is slower, but it is provided as an hedge to combat unforseen analytical advances against Curve25519 and SHA-256. The way the derived binary secret string is encoded into a mpint before it is hashed (i.e., adding or removing zero-bytes for encoding) raises the potential for a side-channel attack which could determine the length of what is hashed. This would leak the most significant bit of the derived secret, and/or allow detection of when the most significant bytes are zero. For backwards compatibility reasons it was decided not to adress this potential problem. 5. IANA Considerations IANA is requested to add "curve25519-sha256" and "curve448-sha512" to the "Key Exchange Method Names" registry for SSH that was created in RFC 4250 section 4.10 [RFC4250]. Adamantiadis, et al. Expires September 28, 2017 [Page 4] Internet-Draft Curve25519/448 for SSH March 2017 6. References 6.1. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC4250] Lehtinen, S. and C. Lonvick, Ed., "The Secure Shell (SSH) Protocol Assigned Numbers", RFC 4250, DOI 10.17487/RFC4250, January 2006, . [RFC4251] Ylonen, T. and C. Lonvick, Ed., "The Secure Shell (SSH) Protocol Architecture", RFC 4251, DOI 10.17487/RFC4251, January 2006, . [RFC4253] Ylonen, T. and C. Lonvick, Ed., "The Secure Shell (SSH) Transport Layer Protocol", RFC 4253, DOI 10.17487/RFC4253, January 2006, . [RFC4634] Eastlake 3rd, D. and T. Hansen, "US Secure Hash Algorithms (SHA and HMAC-SHA)", RFC 4634, DOI 10.17487/RFC4634, July 2006, . [RFC5656] Stebila, D. and J. Green, "Elliptic Curve Algorithm Integration in the Secure Shell Transport Layer", RFC 5656, DOI 10.17487/RFC5656, December 2009, . [RFC7748] Langley, A., Hamburg, M., and S. Turner, "Elliptic Curves for Security", RFC 7748, DOI 10.17487/RFC7748, January 2016, . 6.2. Informative References [Curve25519] Bernstein, D., "Curve25519: New Diffie-Hellman Speed Records", Lecture Notes in Computer Science (LNCS) vol 3958, pp. 207-228, February 2006, . [Ed448-Goldilocks] Hamburg, , "Ed448-Goldilocks, a new elliptic curve", June 2015, . Adamantiadis, et al. Expires September 28, 2017 [Page 5] Internet-Draft Curve25519/448 for SSH March 2017 Appendix A. Copying conditions Regarding this entire document or any portion of it, the authors make no guarantees and are not responsible for any damage resulting from its use. The authors grant irrevocable permission to anyone to use, modify, and distribute it in any way that does not diminish the rights of anyone else to use, modify, and distribute it, provided that redistributed derivative works do not contain misleading author or version information. Derivative works need not be licensed under similar terms. Authors' Addresses Aris Adamantiadis libssh Email: aris@badcode.be Simon Josefsson SJD AB Email: simon@josefsson.org Mark D. Baushke Juniper Networks, Inc. Email: mdb@juniper.net Adamantiadis, et al. Expires September 28, 2017 [Page 6]