6man B. E. Carpenter
Internet-Draft Univ. of Auckland
Updates: 2460, 2780 (if approved) S. Jiang
Intended status: Standards Track Huawei Technologies Co., Ltd
Expires: May 17, 2013 November 13, 2012

Transmission of IPv6 Extension Headers
draft-carpenter-6man-ext-transmit-01

Abstract

Various IPv6 extension headers have been defined since the IPv6 standard was first published. This document updates RFC 2460 to clarify how intermediate nodes should deal with such extension headers and with any that are defined in future. It also specifies how extension headers should be registered by IANA, with a corresponding minor update to RFC 2780.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http:/⁠/⁠datatracker.ietf.org/⁠drafts/⁠current/⁠.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on May 17, 2013.

Copyright Notice

Copyright (c) 2012 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http:/⁠/⁠trustee.ietf.org/⁠license-⁠info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.


Table of Contents

1. Introduction

An initial set of IPv6 extension headers was defined by [RFC2460], which also described how they should be handled by intermediate nodes, with the exception of the hop-by-hop options header:

"...extension headers are not examined or processed
by any node along a packet's delivery path, until the packet reaches
the node (or each of the set of nodes, in the case of multicast)
identified in the Destination Address field of the IPv6 header."

This provision allowed for the addition of new extension headers, since it means that forwarding nodes should be completely transparent to them. Thus, new extension headers could be introduced progressively, used only by hosts that have been updated to create and interpret them. Several such extension headers have been defined since RFC 2460.

Unfortunately, experience has showed that the network is not transparent to these headers. The main reason for this is that some firewalls attempt to inspect the transport header or payload. This means that they need to traverse the chain of extension headers, if present, until they find the transport header (or an encrypted payload). Unfortunately, because some IPv6 extension headers do not follow a uniform TLV format, this process is clumsy and requires knowledge of each extension header's format.

The process is slow as well as clumsy, precluding its use in nodes attempting to process packets at line speed. The present document does not intend to solve this problem, which is caused by the fundamental architecture of IPv6 extension headers. This document focuses on clarifying how the header chain should be traversed in the current IPv6 architecture.

If they encounter an unknown extension header type, some firewalls treat the packet as suspect and drop it. It is an established fact that several widely used firewalls do not recognise some or all of the extension headers defined since RFC 2460. It has also been observed that certain firewalls do not even handle all the extension headers in RFC 2460, including the fragment header [I-D.taylor-v6ops-fragdrop], causing fundamental problems of connectivity. This applies in particular to firewalls that attempt to inspect packets statelessly at very high speed, since they cannot take the time to reassemble fragmented packets, especially when under a denial of service attack.

Other types of middlebox, such as load balancers or packet classifiers, might also fail in the presence of extension headers that they do not recognise.

A contributory factor to this problem is that, because extension headers are numbered out of the existing IP Protocol Number space, there is no collected list of them. For this reason, it is hard for an implementor to quickly identify the full set of defined extension headers. An implementor who consults only RFC 2460 will miss all extension headers defined subsequently.

The uniform TLV format now defined for extension headers [RFC6564] will improve the situation, but only for future extensions. Some tricky cases would be avoided by forbidding very long chains of extension headers that might otherwise be fragmented [I-D.ietf-6man-oversized-header-chain].

However, these changes are insufficient to correct the underlying problem. The present document clarifies that the above requirement from RFC 2460 applies to all types of node that forward IPv6 packets and to all extension headers defined now and in the future. It also requests IANA to create a subsidiary registry that clearly identifies extension header types, and updates RFC 2780 accordingly. However, fundamental changes to the IPv6 extension header architecture are out of scope for this document.

Also, Hop-by-Hop options are not handled by many high speed routers, or are processed only on a slow path. This document also updates the requirements for processing the Hop-by-Hop options header to make them more realistic.

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].

2. Requirement to Transmit Extension Headers

The IPv6 Hop-by-Hop Options header SHOULD be processed by intermediate nodes as described in [RFC2460]. However, it is to be expected that high performance routers will either ignore it, or assign packets containing it to a slow processing path. Designers planning to use a Hop-by-Hop option should be aware of this likely behaviour.

As a reminder, in RFC 2460, it is stated that the Hop-by-Hop Options header, if present, must be first.

Apart from that, any node along an IPv6 packet's path, which forwards it for any reason, SHOULD do so regardless of any extension headers that are present, as described in RFC 2460. Exceptionally, if this node is designed to examine extension headers for any reason, such as firewalling, it MUST recognise and deal appropriately with all IPv6 extension header types. The list of currently defined extension header types is maintained by IANA (see Section 4).

RFC 2460 requires destination hosts to discard packets containing unrecognised extension headers. However, intermediate forwarding nodes MUST NOT do this by default, since that might cause them to inadvertently discard traffic using a recently defined extension header, not yet recognised by the intermediate node.

As mentioned above, firewalls that violate RFC 2460 by discarding packets containing extension headers are known to cause connectivity failures. Therefore, it is important that firewalls are capable of parsing all defined IPv6 extension headers and behave according to the above requirements. If a firewall chooses to discard a packet containing a defined IPv6 extension header, it MUST be the result of an explicitly configured firewall policy, and not just the result of a failure to recognise such a header. To be clear, this means that the default configuration of a firewall MUST NOT cause defined extension headers to be discarded. Explicit configuration of a discard policy is needed to change this.

The IPv6 Routing Header Types 0 and 1 have been deprecated and SHOULD NOT be used. However, as specified in [RFC5095], this does not mean that the IPv6 Routing Header can be unconditionally dropped by forwarding nodes. Packets containing undeprecated Routing Headers MUST be forwarded by default. At the time of writing, these include Type 2 [RFC6275], Type 3 [RFC6554], and Types 253 and 254 [RFC4727]. Others may be defined in future.

3. Security Considerations

Firewall devices MUST conform to the requirements in the previous section in order to respect the IPv6 extension header architecture. In particular, packets containing specific extension headers are only to be discarded as a result of explicit policy, and never as a result of the default configuration.

When new extension headers are defined in the future, those implementing and configuring firewalls will need to take account of them. It is to be expected that this process will be slow. Until it is complete, the new extension will fail in some parts of the Internet. This aspect needs to be considered when deciding to standardise a new extension.

4. IANA Considerations

IANA is requested to clearly mark in the Assigned Internet Protocol Numbers registry those values which are also IPv6 Extension Header types, for example by adding an extra column to indicate this. This will also apply to any IPv6 Extension Header types defined in the future.

Additionally, IANA is requested to replace the existing empty IPv6 Next Header Types registry by an IPv6 Extension Header Types registry. It will contain only those protocol numbers which are also marked as IPv6 Extension Header types in the Assigned Internet Protocol Numbers registry. The initial list will be as follows:

The references to the IPv6 Next Header field in [RFC2780] are to be interpreted as also applying to the IPv6 Extension Header field.

5. Acknowledgements

This document was triggered by mailing list discussions including John Leslie, Stefan Marksteiner and others. Valuable comments and contributions were made by Dominique Barthel, Lorenzo Colitti, Fernando Gont, Suresh Krishnan, Michael Richardson, Dave Thaler, Joe Touch, and others.

Brian Carpenter was a visitor at the Computer Laboratory, Cambridge University during part of this work.

This document was produced using the xml2rfc tool [RFC2629].

6. Change log [RFC Editor: Please remove]

draft-carpenter-6man-ext-transmission-01: feedback at IETF85: clarify scope and impact on firewalls, discuss line-speed processing and lack of uniform TLV format, added references, restructured IANA considerations, 2012-11-13.

draft-carpenter-6man-ext-transmission-00: original version, 2012-08-14.

7. References

7.1. Normative References

[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC2460] Deering, S.E. and R.M. Hinden, "Internet Protocol, Version 6 (IPv6) Specification", RFC 2460, December 1998.
[RFC2780] Bradner, S. and V. Paxson, "IANA Allocation Guidelines For Values In the Internet Protocol and Related Headers", BCP 37, RFC 2780, March 2000.
[RFC5533] Nordmark, E. and M. Bagnulo, "Shim6: Level 3 Multihoming Shim Protocol for IPv6", RFC 5533, June 2009.
[RFC5095] Abley, J., Savola, P. and G. Neville-Neil, "Deprecation of Type 0 Routing Headers in IPv6", RFC 5095, December 2007.
[RFC4302] Kent, S., "IP Authentication Header", RFC 4302, December 2005.
[RFC4303] Kent, S., "IP Encapsulating Security Payload (ESP)", RFC 4303, December 2005.
[RFC5201] Moskowitz, R., Nikander, P., Jokela, P. and T. Henderson, "Host Identity Protocol", RFC 5201, April 2008.
[RFC6275] Perkins, C., Johnson, D. and J. Arkko, "Mobility Support in IPv6", RFC 6275, July 2011.
[RFC6564] Krishnan, S., Woodyatt, J., Kline, E., Hoagland, J. and M. Bhatia, "A Uniform Format for IPv6 Extension Headers", RFC 6564, April 2012.
[RFC4727] Fenner, B., "Experimental Values In IPv4, IPv6, ICMPv4, ICMPv6, UDP, and TCP Headers", RFC 4727, November 2006.

7.2. Informative References

[RFC2629] Rose, M.T., "Writing I-Ds and RFCs using XML", RFC 2629, June 1999.
[RFC6554] Hui, J., Vasseur, JP., Culler, D. and V. Manral, "An IPv6 Routing Header for Source Routes with the Routing Protocol for Low-Power and Lossy Networks (RPL)", RFC 6554, March 2012.
[I-D.ietf-6man-oversized-header-chain] Gont, F and V Manral, "Security and Interoperability Implications of Oversized IPv6 Header Chains", Internet-Draft draft-ietf-6man-oversized-header-chain-02, November 2012.
[I-D.taylor-v6ops-fragdrop] Jaeggli, J, Colitti, L, Kumari, W, Vyncke, E, Kaeo, M and T Taylor, "Why Operators Filter Fragments and What It Implies", Internet-Draft draft-taylor-v6ops-fragdrop-00, October 2012.

Authors' Addresses

Brian Carpenter Department of Computer Science University of Auckland PB 92019 Auckland, 1142 New Zealand EMail: brian.e.carpenter@gmail.com
Sheng Jiang Huawei Technologies Co., Ltd Q14, Huawei Campus No.156 Beiqing Road Hai-Dian District, Beijing, 100095 P.R. China EMail: jiangsheng@huawei.com