6man R. Bonica
Internet-Draft Juniper Networks
Intended status: Standards Track Y. Kamite
Expires: May 23, 2020 NTT Communications Corporation
L. Jalil
C. Lenart
Verizon
N. So
F. Xu
Reliance Jio
G. Presbury
Hughes Network Systems
G. Chen
Baidu
Y. Zhu
China Telecom
Y. Zhou
ByteDance
November 20, 2019

The Per-Path Service Instruction (PPSI) Option
draft-bonica-6man-vpn-dest-opt-08

Abstract

SRm6 encodes Per-Path Service Instructions (PPSI) in a new IPv6 option, called the PPSI Option. This document describes the PPSI Option.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on May 23, 2020.

Copyright Notice

Copyright (c) 2019 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.


Table of Contents

1. Introduction

An SRm6 path provides unidirectional connectivity from its ingress node to its egress node. While an SRm6 path can follow the least cost path from ingress to egress, it can also follow any other path.

SRm6 paths are encoded as IPv6 header chains. When an SRm6 ingress node receives a packet, it encapsulates the packet in an IPv6 header chain. It then forwards the encapsulated packet to the path's egress node. When the egress node receives the packet, it processes the SRm6 payload (i.e., the original packet).

SRm6 paths are programmable. They support several instruction types, including Per-Path Service Instructions (PPSI). PPSIs determine how path egress nodes process SRm6 payloads. In the absence of a PPSI, the egress node processes SRm6 payloads as described in [RFC8200].

The following are examples of PPSIs:

SRm6 encodes PPSIs in a new IPv6 option, called the PPSI Option. This document describes the PPSI Option.

PPSIs can be used to support Virtual Private Networks (VPN). Therefore, Appendix A of this document describes VPN technology and how PPSIs can be used to support a VPN.

2. Requirements Language

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC8174] when, and only when, they appear in all capitals, as shown here.

3. PPSI Identifiers

PPSI Identifiers identify PPSIs. When a path egress node instantiates a PPSI, it also allocates a PPSI Identifier and associates the PPSI with the identifier.

PPSI Identifiers have node-local significance. This means that a path egress node must assign a unique PPSI Identifier to each PPSI that it instantiates. However, one path egress node can assign a PPSI Identifier to an instruction that it instantiates, while another path egress node can assign the same PPSI Identifier to a different PPSI that it instantiates.

4. The PPSI Option

The PPSI Option contains the following fields:

The SRm6 PPSI option MAY appear in a Destination Options header that precedes an upper-layer header. It MUST NOT appear in a Hop-by-hop Options header or in a Destination Options header that precedes a Routing header.

When the SRm6 PPSI option appears in a Destination Options header, it MUST be the only option listed in the header. This is because the PPSI defines all path egress node behaviors.

NOTE : The highest-order two bits of the Option Type (i.e., the "act" bits) are 10. These bits specify the action taken by a destination node that does not recognize the option. The required action is to discard the packet and, regardless of whether or not the packet's Destination Address was a multicast address, send an ICMPv6 Parameter Problem, Code 2, message to the packet's Source Address, pointing to the unrecognized Option Type.

The third highest-order bit of the Option Type (i.e., the "chg" bit) is 0. This indicates that Option Data cannot be modified along the path between the packet's source and its destination.

5. Destination Option Header Considerations

As per [RFC8200], the Destination Options header includes a Next Header field. The Next Header field identifies the header following the Destination Options header.

SRm6 can carry Ethernet payload after a Destination option header. Therefore, this document requests IANA to assign a protocol number for Ethernet. (The suggested value is 143.)

6. ICMPv6 Considerations

SRm6 implementations MUST comply with the ICMPv6 processing rules specified in Section 2.4 of [RFC4443]. For example:

7. Security Considerations

SRm6 domains MUST NOT span security domains. In order to enforce this requirement, security domain edge routers MUST do one of the following:

8. IANA Considerations

IANA is requested to allocate a code point from the Destination Options and Hop-by-hop Options registry (https://www.iana.org/assignments/ipv6-parameters/ipv6-parameters.xhtml#ipv6-parameters-2). This option is called "Per-Path Service Instruction Option". The "act" bits are 10 and the "chg" bit is 0. The suggested value is 144.

IANA is also requested to allocate a code point for Ethernet from the Assigned Internet Protocol Numbers registry (https://www.iana.org/assignments/protocol-numbers/protocol-numbers.xhtml). The suggested value is 143.

9. Acknowledgements

Thanks to Brian Carpenter, Adrian Farrel, Tom Herbert, John Leddy and Tony Li for their comments.

10. References

10.1. Normative References

[I-D.bonica-spring-srv6-plus] Bonica, R., Hegde, S., Kamite, Y., Alston, A., Henriques, D., Jalil, L., Halpern, J., Linkova, J. and G. Chen, "Segment Routing Mapped To IPv6 (SRm6)", Internet-Draft draft-bonica-spring-srv6-plus-06, October 2019.
[RFC0791] Postel, J., "Internet Protocol", STD 5, RFC 791, DOI 10.17487/RFC0791, September 1981.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997.
[RFC4302] Kent, S., "IP Authentication Header", RFC 4302, DOI 10.17487/RFC4302, December 2005.
[RFC4303] Kent, S., "IP Encapsulating Security Payload (ESP)", RFC 4303, DOI 10.17487/RFC4303, December 2005.
[RFC4443] Conta, A., Deering, S. and M. Gupta, "Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6) Specification", STD 89, RFC 4443, DOI 10.17487/RFC4443, March 2006.
[RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017.
[RFC8200] Deering, S. and R. Hinden, "Internet Protocol, Version 6 (IPv6) Specification", STD 86, RFC 8200, DOI 10.17487/RFC8200, July 2017.

10.2. Informative References

[RFC2784] Farinacci, D., Li, T., Hanks, S., Meyer, D. and P. Traina, "Generic Routing Encapsulation (GRE)", RFC 2784, DOI 10.17487/RFC2784, March 2000.
[RFC3031] Rosen, E., Viswanathan, A. and R. Callon, "Multiprotocol Label Switching Architecture", RFC 3031, DOI 10.17487/RFC3031, January 2001.
[RFC4364] Rosen, E. and Y. Rekhter, "BGP/MPLS IP Virtual Private Networks (VPNs)", RFC 4364, DOI 10.17487/RFC4364, February 2006.
[RFC4761] Kompella, K. and Y. Rekhter, "Virtual Private LAN Service (VPLS) Using BGP for Auto-Discovery and Signaling", RFC 4761, DOI 10.17487/RFC4761, January 2007.
[RFC4762] Lasserre, M. and V. Kompella, "Virtual Private LAN Service (VPLS) Using Label Distribution Protocol (LDP) Signaling", RFC 4762, DOI 10.17487/RFC4762, January 2007.
[RFC6624] Kompella, K., Kothari, B. and R. Cherukuri, "Layer 2 Virtual Private Networks Using BGP for Auto-Discovery and Signaling", RFC 6624, DOI 10.17487/RFC6624, May 2012.
[RFC7432] Sajassi, A., Aggarwal, R., Bitar, N., Isaac, A., Uttaro, J., Drake, J. and W. Henderickx, "BGP MPLS-Based Ethernet VPN", RFC 7432, DOI 10.17487/RFC7432, February 2015.
[RFC8077] Martini, L. and G. Heron, "Pseudowire Setup and Maintenance Using the Label Distribution Protocol (LDP)", STD 84, RFC 8077, DOI 10.17487/RFC8077, February 2017.

Appendix A. Virtual Private Networks (VPN)

Virtual Private Network (VPN) technologies allow network providers to emulate private networks with shared infrastructure. For example, assume that red sites and blue sites connect to a provider network. The provider network facilitates communication among red sites and facilitates communication among blue sites. However, it prevents communication between red sites and blue sites.

The IETF has standardized many VPN technologies, including:

The above-mentioned technologies include the following components:

CE devices participate in closed communities called VPNs. CEs that participate in one VPN can communicate with one another but cannot communicate with CEs that participate in another VPN.

CE devices connect to provider networks through PE devices. Each PE maintains one Routing Instance for each VPN that it supports. A Routing Instance is a VPN specific Forwarding Information Base (FIB). In EVPN, Routing Instances are called Ethernet Virtual Instances (EVI).

Assume that one CE sends a packet through a provider network to another CE. The packet enters the provider network through an ingress PE and leaves the provider network through an egress PE. The packet may traverse one or more intermediate nodes on route from PE to PE.

When the ingress PE receives the packet, it:

If the search fails, the ingress PE discards the packet. If the search succeeds, it yields the following:

The ingress PE prepends the Service Instruction Identifier and a transport header to the packet, in that order. It then forwards the packet through a transport tunnel to the egress PE.

The egress PE removes the transport header, if it has not already been removed by an upstream device. It then examines and removes the Service Instruction Identifier. Finally, it executes a service instruction that is associated with the Service Instruction Identifier. The service instruction causes the egress PE to forward the packet to its destination (i.e., a directly connected CE).

In the above-mentioned VPN technologies, the ingress PE encodes Service Instruction Identifiers in Multiprotocol Label Switching (MPLS) labels. Depending upon the transport tunnel type, the transport header can be:

Some PE devices cannot process MPLS headers. While these devices have several alternatives to MPLS-based transport tunnels, they require an alternative to MPLS-based encoding of Service Instruction Identifiers. The PPSI Option can be used to encode Service Instruction Identifiers . It is applicable when VPN payload is transported over IPv6.

Authors' Addresses

Ron Bonica Juniper Networks 2251 Corporate Park Drive Herndon, Virginia 20171 USA EMail: rbonica@juniper.net
Yuji Kamite NTT Communications Corporation 3-4-1 Shibaura, Minato-ku Tokyo, 108-8118 Japan EMail: y.kamite@ntt.com
Luay Jalil Verizon Richardson, Texas USA EMail: luay.jalil@one.verizon.com
Chris Lenart Verizon 22001 Loudoun County Parkway Ashburn, Virginia 20147 USA EMail: chris.lenart@verizon.com
Ning So Reliance Jio 3010 Gaylord PKWY, Suite 150 Frisco, Texas 75034 USA EMail: Ning.So@ril.com
Fengman Xu Reliance Jio 3010 Gaylord PKWY, Suite 150 Frisco, Texas 75034 USA EMail: Fengman.Xu@ril.com
Greg Presbury Hughes Network Systems 11717 Exploration Lane Germantown, Maryland 20876 USA EMail: greg.presbury@hughes.com
Gang Chen Baidu No.10 Xibeiwang East Road Haidian District Beijing, 100193 P.R. China EMail: phdgang@gmail.com
Yongqing Zhu China Telecom 109 West Zhongshan Ave, Tianhe District Guangzhou, P.R. China EMail: zhuyq.gd@chinatelecom.cn
Yifeng Zhou ByteDance Building 1, AVIC Plaza, 43 N 3rd Ring W Rd Haidian District Beijing, 100000 P.R. China EMail: yifeng.zhou@bytedance.com