Network Working Group B. Black Internet-Draft Layer8 Networks Expires: May 9, 2002 K. Kompella Juniper Networks November 8, 2001 MTU Signalling Extensions for LDP draft-black-ldp-mtu-extensions-01 Status of this Memo This document is an Internet-Draft and is in full conformance with all provisions of Section 10 of RFC2026. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF), its areas, and its working groups. Note that other groups may also distribute working documents as Internet-Drafts. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." The list of current Internet-Drafts can be accessed at http://www.ietf.org/ietf/1id-abstracts.txt. The list of Internet-Draft Shadow Directories can be accessed at http://www.ietf.org/shadow.html. This Internet-Draft will expire on May 9, 2002. Copyright Notice Copyright (C) The Internet Society (2001). All Rights Reserved. Abstract Proper functioning of RFC 1191 path MTU detection requires that IP routers have knowledge of the MTU for each link to which they are connected [1]. As currently specified in [3], LDP does not have the ability to signal the MTU for an LSP to ingress LSRs. This document specifies extensions to the LDP label distribution protocol in support of LSP MTU signalling. Black & Kompella Expires May 9, 2002 [Page 1] Internet-Draft MTU Signalling Extensions for LDP November 2001 1. Introduction As currently specified in [3], the LDP protocol for MPLS does not support signalling of the MTU for LSPs to ingress LSRs. This functionality is essential to the proper functioning of RFC 1191 path MTU detection [1]. Without knowledge of the MTU for an LSP, edge LSRs may transmit packets along that LSP which are, according to [4], too big. Such packets may be silently discarded by LSRs along the LSP, effectively preventing communication between certain end hosts. The solution proposed in this document enables automatic determination of the MTU for an LSP with the addition of a TLV to carry MTU information for a FEC between adjacent LSRs in LDP Label Mapping messages. This information is sufficient for a set of LSRs along the path followed by an LSP to discover either the exact MTU for that LSP, or an approximation which is no worse than could be generated with local information on the ingress LSR. Black & Kompella Expires May 9, 2002 [Page 2] Internet-Draft MTU Signalling Extensions for LDP November 2001 2. MTU Signalling The signalling procedure described in this document employs the addition of a single TLV to LDP Label Mapping messages and a simple algorithm for LSP MTU calculation. 2.1 Signalling Procedure The procedure for signalling the MTU is performed hop-by-hop by each LSR L along an LSP. The steps are as follows: 1. First, L computes the MTU for each FEC. 1. Suppose L is the egress LSR for a FEC. L sets the MTU for this FEC to the MTU of the egress interface for the FEC. If L is not the egress LSR for the FEC, then it should set its MTU to 0xffff, indicating that it is not the egress LSR and has not yet received an MTU other than 0xffff from downstream LSRs. As a matter of policy, L may instead determine M to be the minimum MTU of a set of interfaces, up to and including all interfaces in the LSR. 2. Suppose L receives a Mapping for a FEC with an MTU State TLV with MTU M and over an interface with MTU X. L sets its MTU for this FEC (in octets) to the smaller of M and (X - 4). As a matter of policy, L may instead determine M to be the minimum MTU of a set of interfaces, up to and including all interfaces in the LSR. Determining the new MTU by the minimum of M and (X - 4) still holds. If L receives multiple Mapping messages for this FEC, it first chooses between them by some policy, then applies the above calculation for the chosen Mapping. This is the "active Mapping" for this FEC. 3. If L receives a Mapping for a FEC without an MTU State TLV from a directly connected neighbor, L MAY act as if it received an MTU State TLV with MTU 0xffff, and follow the procedure in Step 1b. Otherwise, L MUST send Mappings for this FEC without an MTU State TLV. 4. If L receives a Mapping for a FEC from a neighbor to which it is not directly connected, it must first find an LSP by which L can reach the neighbor. (Note that this procedure may be recursively applied.) Suppose that LSP has MTU M. The LSR then sets the MTU for the FEC to (M - 4), unless over-ridden by policy as in (b). 2. For each direct LDP neighbor of L to which L decides to send a Black & Kompella Expires May 9, 2002 [Page 3] Internet-Draft MTU Signalling Extensions for LDP November 2001 Mapping for a FEC, L attaches an MTU State TLV with the MTU that it computed for this FEC. Mapping messages sent to "remote" LDP neighbors need not have an MTU State TLV. 3. When a new MTU is received for a label mapping from a downstream LSR, or the active Mapping for a FEC changes, L returns to Step 1. If the newly computed MTU is unchanged, L does not advertise new information to its neighbors. This behavior is standard for attributes such as path vector and hop count, and the same rules apply, as specified in [3]. 2.2 Parallel Links and Fast Reroute Paths If, at a given node, multiple LSPs exist for a given FEC, the advertised MTU SHOULD correspond to the smallest MTU of all available LSPs for that FEC. Failure to adhere to this policy may result in excess signalling traffic to update the MTU during path changes, such as after a failure event causes a reroute. 2.3 MTU TLV The MTU TLV encodes information on the maximum transmission unit for an LSP, either for the entire path or only for a segment of the path. The encoding for the MTU TLV is: 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |1|0| MTU TLV (0x0XXX) | Length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | MTU | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ MTU TLV This is a 16-bit unsigned integer that represents the MTU in bytes for an LSP or segment of an LSP. Black & Kompella Expires May 9, 2002 [Page 4] Internet-Draft MTU Signalling Extensions for LDP November 2001 3. Example of Operation The figure and below describes a simple LSR topology. Ri and Re are the ingress and egress LSRs for LSP P1. Rx and Re are the ingress and egress LSRs for LSP P2. From Rx to Re, LSP P1 is encapsulated in LSP P2. Ry is an intermediate LSR which does not act as ingress or egress for any LSPs. L1 through L3 are links connecting the LSRs. MTU Media w/ P2 +--+ +--+ +--+ +--+ Link MTU overhead --|Ri|--L1--|Rx|--L2--|Ry|--L3--|Re|-- ---- ------ -------- +--+ +--+ +--+ +--+ L1 9216 9216 | | ^^ L2 4470 4466 | | || L3 9216 9212 | +---P2-------------+| | | +-------------P1--------------+ Figure 1. Sample LSR Topology The following four time steps illustrate the calculation of the MTU for P1. Let FEC F represent traffic mapped to LSP P1. At t[0]: 1) Re sets the MTU for this F to 9216 and sends a Mapping message for F to Ry. 2) Ri, Rx, and Ry have not received Mappings for F. At t[1]: 1) Ry receives a Mapping for F from Re with an MTU of 9216. Ry compares 9216 to (9212 - 4), and sends a Mapping message for F with an MTU of 9208 to Rx. 2) Ri and Rx have not received Mappings for F. At t[2]: 1) Rx receives a Mapping for F from Ry with an MTU of 9212. Rx compares 9208 to (4466 - 4), and sends a Mapping message for F with an MTU of 4462 to Ri. 2) Ri has not received Mappings for F. Black & Kompella Expires May 9, 2002 [Page 5] Internet-Draft MTU Signalling Extensions for LDP November 2001 At t[3]: 1) Ri receives a Mapping for F from Rx with an MTU of 4462. Ri compares 4462 to (9216 - 4), and sets the MTU for P1 to 4462. Black & Kompella Expires May 9, 2002 [Page 6] Internet-Draft MTU Signalling Extensions for LDP November 2001 4. Protocol Interaction 4.1 Interaction With LSRs Which Do Not Support MTU Signalling Changes in MTU for sections of an LSP may cause intermediate LSRs to generate unsolicited label Mapping messages to advertise the new MTU. LSRs which do not support MTU signalling MUST accept these messages, but MAY ignore them (see Section 2.1). 4.2 Interaction with CR-LDP and RSVP-TE The MTU TLV can be used to discover the Path MTU of both LDP LSPs and CR-LDP LSPs. This proposal is not impacted in the presence of LSPs created using CR-LDP, as specified in [2]. Note that LDP/CR-LDP LSPs may tunnel through other LSPs signalled using LDP, CR-LDP or RSVP-TE [5]; the mechanism suggested here applies in all these cases. Black & Kompella Expires May 9, 2002 [Page 7] Internet-Draft MTU Signalling Extensions for LDP November 2001 5. Security Considerations This mechanism does not introduce any new weaknesses in LDP. It is possible to spoof TCP packets belonging to an LDP session to manipulate the LSP MTU, but this sort of attack is not new to LDP. Black & Kompella Expires May 9, 2002 [Page 8] Internet-Draft MTU Signalling Extensions for LDP November 2001 6. Acknowledgments We would like to thank Andre Fredette for a number of detailed comments on earlier versions of the signalling mechanism. Danny McPherson and Vijay Gill also gave useful feedback on earlier versions of the draft. Eric Gray has contributed numerous useful suggestions. Black & Kompella Expires May 9, 2002 [Page 9] Internet-Draft MTU Signalling Extensions for LDP November 2001 References [1] Mogul, J. and S. Deering, "Path MTU Discovery", RFC 1191, November 1990. [2] Jamoussi, J., "Constraint-Based LSP Setup Using LDP", July 2000. [3] Andersson, L., Doolan, P., Feldman, N., Fredette, A. and B. Thomas, "LDP Specification", RFC 3036, January 2001. [4] Rosen, E., Tappan, D., Federkow, G., Rekhter, Y., Farinacci, D., Li, T. and A. Conta, "MPLS Label Stack Encoding", RFC 3032, January 2001. [5] Awduche, D., Berger, L. and D. Gan, "RSVP-TE: Extensions to RSVP for LSP Tunnels", February 2001. Authors' Addresses Benjamin Black Layer8 Networks EMail: ben@layer8.net Kireeti Kompella Juniper Networks 1194 N. Mathilda Ave Sunnyvale, CA 94089 US EMail: kireeti@juniper.net Black & Kompella Expires May 9, 2002 [Page 10] Internet-Draft MTU Signalling Extensions for LDP November 2001 Full Copyright Statement Copyright (C) The Internet Society (2001). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC editor function is currently provided by the Internet Society. Black & Kompella Expires May 9, 2002 [Page 11]